If you are looking for more details, kindly visit our website.
The Emergency Pipe Clamp is used for repairing pit holes, splits and corrosion leaks in both steel and cast iron pipe lines. The clamp is totally effective under extreme pressure or temperature. For over 100 years, the Emergency Pipe Clamp has been the universal repair clamp worldwide.
The clamp can be used on pipes for gas, water, oil, or ammonia. The repair lasts for years.
The Emergency Pipe Clamp offers triple savings. These savings include: the cost of new pipe, the time and labor of replacing old pipe, and the expense of shutting down while the work is being done. This can amount to thousands of dollars.
Installation of the Emergency Pipe Clamp is easy. Because of the long open hinge, the two halves of the clamp slide together along the pipe when conditions are crowded. The clamp is usually put on under pressure, without interruption of service. The gasket is cemented into a slight recess in the bottom half side so that the clamp can be installed easily under the most awkward conditions. The Emergency Pipe Clamp is made of ductile iron, strongly proportioned, and fitted with sturdy, electroplated Grade 5 steel bolts. All clamps are E-coated to resist rust. Gaskets are Buna-N.
It can withstand temperatures up to 250 degrees Fahrenheit.
Sort By:
Share this post
A Pipe repair clamp can provide one of the most straightforward solutions to fixing a leaking pipe. They are simple to use, effective on pipes of all sizes and materials and are stocked by most home improvement stores.
Pipe Repair clamps consist of a metal sleeve with a flexible rubber pad inside. To fix the leaking pipe, you simply place the rubber part of the clamp over the area requiring repair, before tightening the screws and nuts which fix the clamp in place.
For more information, please visit Zhiang.
Once fixed in position, the pipe repair clamp will provide a seal over the leak area. When applied properly, a good pipe repair clamp will be effective for many years.
Pipe repair clamps are cheap and easy to use, which makes them a cost-effective alternative to other methods of pipe repair.
Clamps can be picked up for as little as £10; compare that to the £40 average hourly rate for a plumber in the United Kingdom and you can see why clamps are such a popular alternative.
Anyone can install a pipe repair clamp and problems can be fixed quickly &#; it&#;s simply a case of visiting your local home improvements store, buying a clamp and fixing the leaking pipe.
An alternative to industry produced pipe repair clamps are homemade clamps. These are surprisingly easy to make, requiring only a piece of heavy rubber from an old bicycle inner tube and a C-clamp.
The homemade repair clamp works in exactly the same away. You place the rubber over the leaking area and then use the C-clamp to hold it in place. This method of repair may not be as long-lasting as a factory manufactured pipe repair clamp, but it will still fix the leak temporarily until a more permanent solution can be found.
Pipe repair clamps are suitable for most of the pipes found in domestic settings. They can be used on steel, cast iron, plastic and copper pipes.
When using a clamp on softer materials, you should be careful about how much you tighten it as you could end up bending the pipe out of shape, causing further complications.
For more technical repairs such as in industry, it will often be better to seek specialist pipe repair equipment. Some clamps may not otherwise be able to handle the pressure, temperature or chemical makeup of what is being transported through the pipe.
If attempting to repair pipework in an aggressive environment, you should always consult the technical datasheet of the product you are intending to use before undertaking any work.
Pipe repair clamps do have certain limitations, especially when it comes to repairing leaks on elbow bends or sections of tee pipe.
For the clamp to work effectively, it needs to be able to tighten fully around the pipe which isn&#;t possible when the pipe in question doesn&#;t run straight &#; such as in this sprinkler system pipe repair in a furniture workshop.
When this is the case, other solutions such as pipe repair tape, pipe repair bandages or epoxy putty can help to provide a more versatile repair.
Share this post
Want more information on Pipe fixing clamps? Feel free to contact us.